Page 1 of 1

hardtop loose

PostPosted: Fri, 25 Nov 2011 10:32 +0000
by scallan
hi having a problem lately that my hardtop keeps coming loose at the back on the frankinstien bolts and when on a bumpy road it just bangs and bangs and is going to end up driving me mad :( so any help is appriciated

thanks james

Re: hardtop loose

PostPosted: Fri, 25 Nov 2011 11:05 +0000
by charged_rs
scallan wrote:hi having a problem lately that my hardtop keeps coming loose at the back on the frankinstien bolts and when on a bumpy road it just bangs and bangs and is going to end up driving me mad :( so any help is appriciated

thanks james


1. remove your hardtop
2. on the chrome latches at the rear there is a little screw at the side of each latch - remove this and the latch will slide open
3. refit hardtop
4. loosen but (dont remove )the 2 exposed bolts
5. push the little plate under the 2 bolts forward as far as it will go , so it fits tightly against the mushroom bolts
6. retighten bolts
7. close latch and insert screw

job done

Re: hardtop loose

PostPosted: Fri, 25 Nov 2011 11:08 +0000
by scallan
[quote="charged_rs
1. remove your hardtop
2. on the chrome latches at the rear there is a little screw at the side of each latch - remove this and the latch will slide open
3. refit hardtop
4. loosen but (dont remove )the 2 exposed bolts
5. push the little plate under the 2 bolts forward as far as it will go , so it fits tightly against the mushroom bolts
6. retighten bolts
7. close latch and insert screw

job done[/quote]


have done this probaly 10 times in the last week with no avail :roll:

Re: hardtop loose

PostPosted: Fri, 25 Nov 2011 11:21 +0000
by charged_rs
chances are the plastic keeper ( edge) on the plate under the 2 bolts are worn out.
you need the build up the keeper again

remove plate completely and wrap the leading edge bit ( should be thick white plastic) up in insulating tape , nice and thick.

if that doest fix it them there is something seriously wrong as this is the only way to adjust your hardtop onto the mushroom bolts. :roll:

Re: hardtop loose

PostPosted: Fri, 25 Nov 2011 12:02 +0000
by scallan
charged_rs wrote:chances are the plastic keeper ( edge) on the plate under the 2 bolts are worn out.
you need the build up the keeper again

remove plate completely and wrap the leading edge bit ( should be thick white plastic) up in insulating tape , nice and thick.

if that doest fix it them there is something seriously wrong as this is the only way to adjust your hardtop onto the mushroom bolts. :roll:



thanks for that charged will try it when i get home as the plastic keepers do seem a lil bit worn hopefully this will work before i go mad with the noise :bom: