MX5Ireland

As the subject says need a BPF3 ECU if anyone's got one for cheap? Many thanks in advance!

Non immobilizer

This is the ECU, and you can see in the 2 pictures the fucked transistors, if anyone knows someone that maybe can even repair it? I don't want to go down the road of buying one for 120 just yet

That looks like corrision on the circuit board in the first picture ? How did you find out the transistors are faulty ?
The leg from diode D004 does not look too good where it enters the board - it looks like corrosion or maybe just a dry joint. The dull colour joints on the transistor could be dry joints too. Reflowing the solder with a hot soldering iron can cure this.

Thank you for your reply, but I got a new ECU and the car starts and runs good, but a new issue has taken place where when I put the car in any gear the revs go up to about 2k, with the clutch still pressed in, and when I put it back to neutral the revs drop to 1k, still with the clutch pressed in ....I'm so sick of this car not giving me a fucking break

That is bad luck indeed. Are you sure nothing is snagging the throttle cable ? Does it stay stationary on the throttle body when the gear stick is moved ?

Just a quick update on the situation, it's fixed now!! The problem was in the upper clutch switch, the spring was broken which I replaced with a pring from a pen and all is 100% just need to set the base idle and everything should be a1. Also on a different note, are magnecor leads that great to pay 100euro for them? Cheers

no way... good to hear you found the root of the issue. Personally... I'd go NGK, you can get them from Moss :
https://www.moss-europe.co.uk/ht-lead-s ... 1116x.html