MX5Ireland

My clutch is starting to slip, what bits do I need, its a 91...

Thanks


g

clutch pressure plate and release bearing .

Dunno what these are like but seem good value


http://cgi.ebay.co.uk/MAZDA-Eunos-Roads ... 2eab60036c

I finally need to replace the clutch, I've been nursing it for ages now, even the old grannies are faster at taking off at the lights.

I just want a standard clutch for a 1991 1.6, which one of these would anyone recommend?

http://www.mx5parts.co.uk/advanced_sear ... it&x=0&y=0

g

http://www.autolinkmx5.com/clutch-kit-m ... 1-61-p.asp

these clutches are good
Ive fitted a few , just make sure and order a new spigot bearing aswell for the flywheel, they only cost a few quid and while youre there you might aswell change it too.

Thanks Steve, but I'm really looking to order one from mx5parts as I've a few other bits I'm going to order... any other suggestions?

g

can't go wrong with sachs but exedy are good make aswell so you can't go to wrong with either.