432HP V8 Flyin Miata
Posted: Thu, 08 May 2014 10:45 +0000Clean conversion! The noise is nice but it doesn't seem to rev too much?
Nico
MX5Ireland
A little corner set aside for MX-5 enthusiasts
http://www.mx5ireland.com/forum/
432HP V8 Flyin Miata
Page 1 of 1
Posted: Thu, 08 May 2014 10:45 +0000Re: 432HP V8 Flyin Miata
Posted: Fri, 09 May 2014 7:20 +0000Re: 432HP V8 Flyin Miata
Posted: Fri, 09 May 2014 9:09 +0000Saw this too. It's V8..it's all about power. Did you see the torque it produces?! 417 ftlbs in total. It's 300 ftlbs at 1500 rpm (mine is idling at that 
) 350 at 2500 and 400 at 4000 rpm. This thing has mad power!
Deivis
) 350 at 2500 and 400 at 4000 rpm. This thing has mad power! Deivis
Re: 432HP V8 Flyin Miata
Posted: Sat, 10 May 2014 12:05 +0000FM II 
1999 Miata on the dyno. The car's fitted with an FM II turbo system using a Hydra ECU, a Flyin' Miata 3" exhaust and stock engine internals. It pulled 263 rear wheel horsepower (uncorrected) at 5000' elevation. 10 psi of boost.
1999 Miata on the dyno. The car's fitted with an FM II turbo system using a Hydra ECU, a Flyin' Miata 3" exhaust and stock engine internals. It pulled 263 rear wheel horsepower (uncorrected) at 5000' elevation. 10 psi of boost.
Re: 432HP V8 Flyin Miata
Posted: Sat, 10 May 2014 9:48 +0000I'd rather have that 
But to each his own I guess..
That's a nice number for the MK2, after reading everywhere that stock rods are made of chocolate.. Key is to make power without torque I guess, with low boost but high flowing turbo..
Nico
But to each his own I guess..That's a nice number for the MK2, after reading everywhere that stock rods are made of chocolate.. Key is to make power without torque I guess, with low boost but high flowing turbo..
Nico
Re: 432HP V8 Flyin Miata
Posted: Sat, 10 May 2014 3:21 +0000V-tec
Deivis
Deivis