MX5Ireland

I'm replacing the softop but have ran into a problem, the previous top was sealed directly to the beltline moulding with some sort of rubber sealer which has bonded to it, I managed to get the vinyl away from the moulding ok but trying to get the sealer off the moulding is almost impossible, it's like rubber bonded to rubber, anyone got an idea how to dissolve the sealer? I've tried thinners and wd40 without much success

Sent from my ELE-L09 using Tapatalk

Hairdryer?

Sent from my Redmi Note 5 using Tapatalk

Hi Steve, I tried a heat gun on it with no success, it just softened everything so I didn't try too long incase it ruined the moulding

Sent from my ELE-L09 using Tapatalk

Hmmm.... Def needs a solvent of some sort then I'd say

Sent from my Redmi Note 5 using Tapatalk

I've left some of it soaking in white spirit now, I'll see if I can find some acetone or something similar tomorrow, nothing is ever straightforward on old cars

Sent from my ELE-L09 using Tapatalk

Picked as much of the sealer as I could, what a pain in the,,, fingers, anyway I'll refit it as it is now, if the top doesn't fit properly or leaks then I'll have to get a new moulding.
Cleaned up the metal rails and gave them a coat of hammerite, it's a race now between the flowers growing and the paint drying

Sent from my ELE-L09 using Tapatalk

Sent from my Redmi Note 5 using Tapatalk

All done now, new second hand mk2.5 frame & mohair top fitted, thankfully everything went back reasonably easy and no leaks, it's so much easier to open and close but now I have to give it a good clean

Sent from my ELE-L09 using Tapatalk

Excellent, lookin well!

Sent from my Redmi Note 5 using Tapatalk

Thanks Steve, due to being out of work for the next few weeks I should be able to do all the jobs that I've been putting off, underbody part of the nct is on Sunday so I'll start checking it for that and go from there